Bridge mode
Set up and run sessions to send tokens from one network to another.
Last updated
Set up and run sessions to send tokens from one network to another.
Last updated
Thanks to the Bridge mode, you can replenish wallet balances with native tokens for further activity in the desired network. Bridge mode allows bridging tokens from any available network to another, without being tied to the module's network.
In the Mode section, select Bridge Mode;
In the Run mode section, choose how wallets will be launched:
Parallel: wallets will operate concurrently (multithreaded) with or without proxies;
One-by-one: wallets will be launched one after another with or without proxies;
One-by-one (mobile proxy): wallets will be launched one after another using mobile proxies. Mobile proxies must first be added to the Settings -> section and linked to accounts in the Account Manager.
To launch a pre-prepared group of wallets, select the desired group in the Select Accounts group to launch section;
In the Bridge Type section, select the bridge through which you want to send tokens. All modules offer several bridges to choose from: official bridges and bridges from third-party developers;
If you want to send funds through an official bridge, select it from the list and proceed to the settings. Almost all official bridges work only with the Ethereum network. Therefore, to send ETH to an L2 network via official bridges, you must have ETH on your Ethereum balance;
In the Account Delays section, set the delay between wallet launches in seconds;
Clicking Pro will open the Gas guard setting. If this delay is activated, your wallet will go to sleep if multiple accounts in the same session are ready to work simultaneously after reaching the gas level you set for the software. This is to prevent all these wallets from sending transactions simultaneously after reaching your specified gas level. The standard delay is set between 30 to 150 seconds;
If you are using an official bridge, select Deposit in the Bridge mode field if you want to send tokens from the Ethereum network to Linea, or Withdraw if you want to send funds from Linea to Ethereum.
If you are using a bridge from third-party developers or an official bridge that allows selecting networks other than Ethereum, then in the Chain from and to field, choose the network from which tokens will be sent in the first window and the network to which tokens will be sent in the second window;
Below the network selection fields, there are two informational banners: Min amount, which displays the minimum sending amount, and Trading fee, which shows the bridge's commission excluding gas fees;
Click Update Balances to see the current balance on the wallets;
Select the wallets you want to use in the session;
In the Amount section, there are three functions if you are using the official bridge and two functions if using a third-party bridge:
All - transfers all available tokens on the wallet to the destination network;
Send range - allows you to send tokens within a specified range;
Leave range - allows you to leave a specified range of tokens on the wallets and send only the amount above this range;
Enter the amount range in the required fields and click Apply to selected wallets. The amount for each wallet will be randomly generated within the specified range. The amount applied to the wallet can be seen in the Amount to bridgefield. You can also manually change the amount in this field;
In the Max gas price section, set the maximum gas price in the Ethereum network at which transactions will be made. The software will wait for the gas price to drop to the specified level and will start making transactions when the gas price reaches the value you set. After starting the session, you can change the upper Gwei limit in the Logs & Progress tab, under the Sessions subsection;
To make the wallets work in random order, keep the Randomize wallets checkbox checked;
To start the wallets, click Launch.
Your wallets have been launched. You can track the process of work of your wallets in the section .
